Any kind of machinery products in use process we must in accordance with the normal way of operation, so as to ensure the machine working normally and our own safety, normal operation is quite important for copper platoon processing machine operators, can also extend the service life of copper platoon processing machine.

銅排加工機:http://www.1588h36.cn

Copper platoon processing machine

　　首先,操作人員要按照銅排加工機操作說明書來操作,不得違規操作造成人員、設備的損傷、損壞.銅排加工機的模具以及配件要保持完好.熟悉機器的結構、性能和操作方法.

First of all, the operation personnel to operate according to the copper platoon processing machine operation manual, shall not violate compasses operation personnel, equipment damage, damage, copper platoon processing machine mold and accessories to keep intact. Familiar with the structure of the machine, the performance and operation method.

　　其次,安裝、調試或拆卸模具,必須由熟悉機器的人員按照規定的規程進行.當機器開動時,切勿把手或身體的一部分放在上下模之間,以免發生事故.

Second, installation, debugging, or remove the molds, must be familiar with the machine's personnel shall be carried out in accordance with the prescribed procedures. When the machine start, do not handle or part of the body in between the upper and lower mold, so as to avoid an accident.

　　最后,應定期檢查刀片和沖模刃口鋒利程度,入發現刃口變鈍,應及時修磨或更換.保持油液清潔幾油路通暢,銅排加工機每班給各單元運動部件加潤滑油.必須保證動作靈活與位置正確電氣與液壓元件,發現不正?，F(xiàn)象時必須立即停車檢查.不工作時關斷各單元工作按鈕,關斷操作盤上的電源開關.

Finally, should be regularly check the blade and die sharp edge, the found a dull edge, should be timely sharpening or replacement. Keep the oil clean a few oil unobstructed, add lubricant to each unit in the moving parts in each shift. Must ensure that the flexible motion and position of electric and hydraulic components, correct found abnormal phenomenon must immediately stop check. Don't work button, shut off the unit to shut off the power switch on the panel.